CFR
- Title 1 - General Provisions
- Title 2 - Grants and Agreements
- Title 3 - The President
- Title 4 - Accounts
- Title 5 - Administrative Personnel
- Title 6 - Domestic Security
- Title 7 - Agriculture
- Title 8 - Aliens and Nationality
- Title 9 - Animals and Animal Products
- Title 10 - Energy
- Title 11 - Federal Elections
- Title 12 - Banks and Banking
- Title 13 - Business Credit and Assistance
- Title 14 - Aeronautics and Space
- Title 15 - Commerce and Foreign Trade
- Title 16 - Commercial Practices
- Title 17 - Commodity and Securities Exchanges
- Title 18 - Conservation of Power and Water Resources
- Title 19 - Customs Duties
- Title 20 - Employees' Benefits
- Title 21 - Food and Drugs
- Title 22 - Foreign Relations
- Title 23 - Highways
- Title 24 - Housing and Urban Development
- Title 25 - Indians
- Title 26 - Internal Revenue
- Title 27 - Alcohol, Tobacco Products and Firearms
- Title 28 - Judicial Administration
- Title 29 - Labor
- Title 30 - Mineral Resources
- Title 31 - Money and Finance: Treasury
- Title 32 - National Defense
- Title 33 - Navigation and Navigable Waters
- Title 34 - Education
- Title 35 - Panama Canal
- Title 36 - Parks, Forests, and Public Property
- Title 37 - Patents, Trademarks, and Copyrights
- Title 38 - Pensions, Bonuses, and Veterans' Relief
- Title 39 - Postal Service
- Title 40 - Protection of Environment
- Title 41 - Public Contracts and Property Management
- Title 42 - Public Health
- Title 43 - Public Lands: Interior
- Title 44 - Emergency Management and Assistance
- Title 45 - Public Welfare
- Title 46 - Shipping
- Title 47 - Telecommunication
- Title 48 - Federal Acquisition Regulations System
- Title 49 - Transportation
- Title 50 - Wildlife and Fisheries
572.72—Head assembly and test procedure.
(a) Head assembly.
The head consists of the assembly designated as SA 106 010 on drawing No. SA 106C 001, sheet 2, and conforms to each drawing listed on SA 106C 001, sheet 8.
(b) Head assembly impact response requirements.
When the head is impacted by a test probe conforming to § 572.77(a)(1) at 7 feet per second (fps) according to the test procedure in paragraph (c) of this section, then the resultant head acceleration measured at the location of the accelerometer installed in the headform according to § 577.77(b) is not less than 130g and not more than 160g.
(1)
The recorded acceleration-time curve for this test is unimodal at or above the 50g level, and lies at or above that level for an interval not less than 1.0 and not more than 2.0 milliseconds.
(1)
Seat and orient the dummy on a seating surface having a back support as specified in § 572.78(c), and adjust the joints of the limbs at any setting (between 1g and 2g) which just supports the limbs' weight when the limbs are extended horizontally and forward.
(i)
At the forehead at the point of orthogonal intersection of the head midsagittal plane and the transverse plane which is perpendicular to the Z axis of the head as shown in Figure 40;
(iii)
Coincides within 2 degrees with the line made by the intersection of the horizontal and midsagittal planes passing through this point.
(3)
Impact the head with the test probe so that at the moment of contact the probe's longitudinal center line falls within 2 degrees of a horizontal line in the dummy's midsagittal plane.
Tips